CR-V 2007 to 2011
275 topics in this forum
-
The spark plugs on my 2007 CRV EX need replacing. However, on my engine, the coil packs are on the front of the engine and not under a cover like many of those I’ve seen online. The coil packs are secured with a nut the screws onto a stud that protrudes through the coil pack but the nuts and the securing stud are so badly rusted away (we live near the sea) that I can’t get the nuts off and so can’t remove the coil packs. I’m worried that I might break the stud that the coil pack securing but screws onto, and I’ve not been able to find replacements online. Can anyone help by providing a part number, or a link to where I can buy some replacement studs that coil pack securin…
-
- 2 replies
- 1k views
-
-
-
Hello ,thank you for adding me . I've joined as I had had a CRV for approx 13 year's it's well maintained and I'/ the garage struggling to get a part The master brake cylinder
-
- 0 replies
- 974 views
-
-
I have just fitted a new Bosch Air Filter to my 2008 Mk3 CRV , it sounds simple enough but checking all the info on google ,my handbook and you tube it didnt show me where the Air Filter Housing was for my CRV, So a quick call to Honda and solved the problem on my CRV mine does not have an oblong housing on top of the engine as shown on you tube but is in the engine compartment r/h side with three retaining to unclip and there was the Air Filter , simple change and alls well . but took me a while to find it. Hope this helps other Members BAZZER RN 1
-
- 0 replies
- 949 views
-
-
Hi all, Car is a 2013 MK4 EX UK spec As per the title I get no warning beeps when I lock or unlock the car, also no beeps when I open or close the power tail gate. Some post mention a setting in the audio system but not on mine see pic below. Anyone any ideas, was thinking if someone previously had disconnected the buzzer!
-
- 0 replies
- 941 views
-
-
I need to change the now very old transmission fluid and need the best price as money is tight?
-
- 1 reply
- 937 views
-
-
Hello all, I have a Honda CR-V EX i-VTEC automatic, model year 2007. Last month, my car failed to start when I turned on the engine. It seems the battery had a dead cell and was replaced under warranty. A week later, the car failed to start again! I called RAC, who conducted a battery test and found no issues. They jump-started the car for me, and I was able to take it to the garage, where they confirmed that the battery is healthy and did not show any drops. This morning, my car failed to start once more (Second time since changing battery). It has been 9 days since RAC jump-started it, and my new battery is flat. When I turn off the car, …
-
- 1 reply
- 881 views
-
-
Hello, I have a 2011 CRV 4WD with 140,000 miles. Last year, I noticed a delay when shifting into second gear, and it became jerky. I took it to a mechanic who replaced the transmission fluid, but the issue actually got worse. He then replaced the solenoid, which seemed to help for a few months. After another visit to the mechanic, the diagnostic test indicated an issue, so I ordered new solenoids and had them all replaced. Unfortunately, the problem persisted. Currently, it struggles to shift into second gear. When it does manage to engage, accelerating causes the engine to rev up, and it slips back out of gear.
-
- 1 reply
- 872 views
-
-
Mk3.2 crv 2.2 148bhp diesel 2011. just had the clutch and fly wheel replaced. Since the work has been done the engine engine sound inside the cab is a lot more noticeable. Its not a fault noise just normal engine noise. It's almost as if some sound proofing is missing or a grommet is not put back properly. Ive searched but cant see anythingout of place. Any ideas
-
- 0 replies
- 846 views
-
-
Looking to upgrade audio to DAB and swap out existing radio/cassette,anyone tried it? Keen to source kit including cables and any other parts required many thanks
-
- 1 reply
- 822 views
-
-
-
We love our cr-v so much that after a crash where the extent of bonnet and front end damage vs book value meant a write off I accepted a lower cash offer from insurers and our Honda back home. Now to buy used replacement body parts (some good deals going)and a body shop willing to do the work located. Anyone experienced this? Any body shops recommended? All info gratefully accepted.
-
- 0 replies
- 812 views
-
-
Does anyone have any idea how much a blue Honda 2011 CR-V EX with just under 50 000 miles would have cost in Dec 2020/Jan 2021? Work that needed to be done on it: needed MOT, dud battery replacing, needed 4 new tyres, tracking adjusting, new front brake pads and disks, parking sensor to be replaced, headlight washer bottle replacement. The rear diff was making the usual juddering on full lock from contamination, so needed a full 3 litre drain, flush, fill, drive repeat etc. Body work was relatively good with a few chips that had turned rusty, a bit dog hairy inside (including a nice fluffy cabin filter!), but not excessive. I did a full service on it…
-
- 0 replies
- 804 views
-
-
2010 Honda CR-V Auto Whilst the rear sensors are very loud, the front resemble the squeak of a dying mouse. Honda said that both sounds are made by the same unit and a replacement unit will cost over £350. Any ideas for amplifying the front sensors? Thanks in anticipation Brian Pfeiffer
-
- 0 replies
- 796 views
-
-
Hi my CRV drives absolutely fine ,that is until I put my caravan on the back, it's ok until I come to a hill then engine light comes on and goes into limp mode. I use my obd tool to turn off and reset, next hill light on again. Honda have looked at it and said can't find the fault,anyone got any ideas as I'm getting pretty fed up Codes it's throwing up DTC P1236 BOOST PRESSURE TOO HIGH SIGNAL DTCP00AF TURBORCHARGER BOOST CONTROL POSITION SENSOR IMPLAUSIBLE
-
- 0 replies
- 766 views
-
-
Is there a conversion from drum breaks to disc breaks available for a 2007 MK2 CRV ?
-
- 1 reply
- 762 views
-
-
behind my lower front crankshaft pulley i have a plate with three fasteners and what looks to be two dowel pins this part seems to have swollen as after fitting a new pulley it is fouling it can anyone please tell me what this part does and if its replaceable or if i can just remove it and throw it away
-
- 0 replies
- 747 views
-
-
Just purchased car today, no problems with test drive. Clutch pedal sticking when changing gears. Not always, just once in a while. Have to use toe to lift clutch before changing gear.
-
- 0 replies
- 721 views
-
-
Hello everyone! I'm trying to trace an oil leak on our 2011 Honda CRV with 375Tkm on the clock. It has been parked in the garage for the last couple of years as my wife upgraded to a newer vehicle, and I've been keeping this one as a backup. Well, it's time to retire my current beater and upgrade to this beauty, so I'll finally have to figure out where the oil is going. 🙂 The engine had been leaking oil for the last little while that she drove it, but it would only leak if the engine was running; hence, it never left any oil spots on the driveway. A shop told me it was the oil pan gasket, but I think it is coming from somewhere higher. It looks lik…
-
- 1 reply
- 694 views
-
-
Hi all, I've have a Honda CRV 2010 and my rear window washer jet is blocked. I've followed the advice of you on this matter by reading up on others that have had the same problems and the suggestions that's been offered. I know the route of the pipes via a picture one of you posted so many thanks however I don't know how to remove the inside plastic panels to get to the pipe or how to take off the inner wheel arches without damaging the clips. Will the Haynes manual auto fix show me how?? I don't want to buy it and find it doesn't help, can any of you good people please let me know 1st ?? Many thanks Ian.
-
-
- 1 reply
- 656 views
-
-
Hi when I go into reverse my reverse camera screen has no picture. Just lines down screen. My screen is fine for stereo and sat nav. I have a CRV 2007. has this happened to anyone else so I can get an idea to fix please? Many thanks Paul
-
- 1 reply
- 647 views
-
-
Hi All, I have recently bought a 2007 CR-V Automatic with 118,000 miles on the clock and have two problems that I would like some advice on please. When starting from cold the starter motor makes a noise. I think it is at the stage when the engine has just started and the motor is disengaging. Is this something I should worry about and have fixed or should I just leave it? The automatic gearbox is occasionally behaving oddly. (I am pretty sure it is the gearbox.) It makes a noise that I can only describe as being like running over a gentle rumble strip. It only happens briefly so I am not sure whether it is actually vibrating or jus…
-
- 0 replies
- 642 views
-
-
Just got my first Honda last week, it's not new and looks a bit tired in places. I had a look online if people spruce them up at all and add some personal touches but have found an absolute nada. I've got more of a Ford background and my Fiesta ST had a lot of nice interior and exterior mods done to make it my own but Honda community seems to be more conservative. Is there anyone here that has done any modifications to their car to make them, well, more noticeable? I don't necessarily mean in Hot Rod style but so that I can find my car in the car park more like...
-
- 1 reply
- 527 views
-
-
Hi All, Have just brought my first Honda CRV. Got the EX trim as recommended by a friend, and I’m glad I did. However, there’s a couple of issues I’d like some help with. Firstly, I know there’s a common issue with the diffs crystallising and fluid needing replacing, how often do you do this to avoid the problem? Also, the SatNav CD provided does not work (money was taken off for this) and it seems the SatNav CD will not eject from the slot. To be honest I was planning on upgrading to a new android system with DAB anyways, but I’m not sure the best place to look to get a unit. I would love some help with this,…
-
-
- 1 reply
- 520 views
-
-
Hi, I have the above error code on my 2009 honda crv. It says it's the 2nd clutch pressure switch fault. Has anyone experienced this fault before? If so is it an easy fix? Does anyone know the part number for the switch and where it's located and how to get access please. Thank you.
-
- 0 replies
- 482 views
-