CR-V 2001 to 2006

Just bought myself a 2003 CR-v with sat nav & cd system... Usually there is an accessory position on the ignition swith, not on mine though! One turn of the key brings all dash lights on then next turn starts car, also the radio has to be turned off manually, ie there is no position on the ignition switch for accessories, radio, windows etc... Is this normal? Thanks guys

Help. Anyone know where I can obtain a pair. Have seen a couple on adverts on Ebay but there are various negative feedbacks regarding quality and genuine fitting.

2006 2.0 petrol auto CRV MK2. Had catalytic converter stolen few weeks ago - have now replaced full exhaust system including both sensors. Car starts and runs fine but 6 seconds after starting get er message for open circuit on the O2 sensor connected to the catalytic converter Have tested output and tried replacing sensor but same problem. Note that original sensor had a blue connector but all replacements seem to have a grey connector and same part number - not sure if this means anything. Auto electrician has suggested that output is only 6 ohms and should be above 10? Thanks for looking - appreciate any thoughts.

Fault code P0325 we have tried new knock sensor new plug and still engine light on any advise

When I bought my CR-V, the rear wash did not deliver water to the rear screen. The wiper works fine. I set about it one day and pulled the screenwash through by suction. I reconnected the washer pipe and it produced a lovely jet down the rear screen. I tried it a few times in the following days and it was great. However, with the dry spell we're having at the moment, I haven't had to use the rear wash. I tried it again a few days ago as the rear screen was a bit dusty, and nothing, just an occasional drip. Can anyone give me an idea why the screenwash keeps disappearing and will not pump up again please? It's very annoying rather than life threatening. Thanks in adva…

Hi problem code p2138 throttle /pedal position sensor switch d/e voltage correlation , I Have rang all the dealers to get one but not available main dealer main ,dealer said can’t get one a whole new carburettor £1500.00 , I know what I want it is the black thing on top of the carburettor , I have been on eBay you can get one , but not for my model of car , question can I put any different on my car is it standard for all the models , please can you help the car goes into limb mode I don’t want a whole new carburettor .

Hi, any advice on how to solve this would be much appreciated, as I imagine it will cost me a few quid to sort it. Brief synopsis: The car is an 11 reg plate and as one who drives around loads with the job I was getting sick of road layouts being different in reality to what the sat nav still thought. I purchased a newer disc (eBay, sorry!) and it worked fine for quite some time. It then began to produce an error and told me to contact the manufacturer. As that wasn't expensive I don't mind binning it (I thought!) and took it out and replaced it with the original, which had caused no issues other than being a decade out of date. However…

Initially the master cylinder flange bolt broke off when I pushed in the clutch stopping at a light. I replaced both master and slave even though they had been replaced a year and half before. Although the shop put the clutch slave pin in the wrong way with the rounded end inside the cylinder. I'm not sure if this is what caused the master to blow. I ended up replacing the metal tube/line from the slave cylinder because I bent it trying to tighten the connection in the top of the slave. Now I've bleed the system with a gravity kit I hooked up to the slave. I got my kid to pump the clutch with the bleeder valve closed then opened with pedal to the floor. I did this sever…

Hello thank you for adding me Hello I am looking for a part for my Honda CRV 1 CTD1 SE 2204 cc 2005 reg Part no 46100SKNE21 Have any of you got any ideas how I can get a new part at all please .. the car is perfectly sound and full service history low mileage ...and I'd really like a part and the garage are struggling to find anything. Thank you

Hi, I want to use a fault reader but can't find where to plug it in.crv 2005 2.2 executive. Thanks Carlos

Hello there, my keyless entry has packed up,no previous signs of trouble, key remote fob ok, press the button, zilch, no noise, flashing lights or anything. I'm hoping it's a fuse, but I need to get the bonnet open from ouside, anyone got any ideas please?

Hi I was lucky to buy a used Honda CRV 05 plate about 4 years ago for £1800 with 120k on the clock. I have a good mechanic who has got me through my MOT's and it's been a great car but sadly this last MOT has come up with bad rust under the car and various other serious issues and because of the rust such as brakes and steering on both sides is in danger of collapse, deeming it unworthy of fixing. I live rurally and do drive through a lot of bad surface water due to heavy rains/flooding years round but nothing crazy other than road driving. I'm wondering if the CRV is prone to a badly rusting undercarriage to this degree or have I just been unlucky at the…

hi,I have a crv 2006 the heater blows cold air only ive flushed the rad and the heater matrix and its just about warm as any one had this problem.thanks tony

Has anybody replaced their DVD/Satnav with a better system? If so which one as I,m struggling to find one. There are plenty for the MK3 but not a MK2 Cheers,

Hi Any dangers in buying a used CRV (2003) 2.0 auto with 140k miles... service history and 12 months mot I only do about 4k miles a year ? cheers

We currently have a 2003 golf but we will soon have 3 dogs instead of 1 , two of which labrador size we want to stand/sit in the boot hence looking at a CRV As its to be shared and probably only do about 5000 miles a year we have decided on a auto petrol and we dont really want to send more than £3000 I know its like asking how long is piece of string but is this model version a safe bet for reliability , maintenance etc There are quite a few on autotrader but I know if we buy the wrong one it could cost loads...

How do I replace the plastic headlamp lens on a 2006 mk2 crv

Hi All i am hoping someone can help me. i have an 06 MK11 CRV 2.2 CDTI it has recently developed a knocking noise on the front which i am unable to find the source of nothing cam up on the MOT and i asked them to look hard this isn't the most worrying thing though. When accelerating especially in second i get a strange vibration/wobble coming up through the car. It seems to be when the car is in the power band as the turbo comes on for example. Does the CRV suffer from drive shaft issues or prop bushes? The vibration was defiantly more noticeable when towing. i had the clutch and fly wheel replaced just over a year ago at Honda so i am hoping that it wouldn't…

Hi everyone, I am a new UK owner as of today, and picked up a mk.2 CR-V 2005 facelift with 118k on the clock and in good mechanical condition. The price was cheap (£1500). However, underneath it is looking a bit sad. The car has been coated with some kind of waxoyl-like substance but it is hiding rust, which is now coming through in places. I have taken a video of the worst areas, please watch: https://youtu.be/s-y-HvzHw18 No metal is falling off yet, just the coating. I'm not sure how bad it is structurally speaking. The car has MOT until end of March, and the entire MOT history is almost perfect - no mention of any corrosion at …

smell of burning oil has crv 2.2i-ctdi got a pvc valve

Hi. The zip on the spare wheel hardcover has broken. Any ideas about where I could take it for a repair? Thanks

Hi my car is a 2006 2.2 diesel CRV. I keep getting the following fault on my diagnostic unit. I have read this relates to the heater plugs but they are all working well and I can get the fault for several minutes after getting going. After that it stays off until the next time you use it. It puts the car into limp mode so I am presently resetting it every time I use the car which is a pain. Any help would be greatly appreciated thanks.

Hi can anybody help i have a Honda CR-VCTDISPORT 2006 . I HAVE PURCHASED FROM EBAY 2 PARCEL SHELFS BUT WHEN YOU FIX IT TO THE SIDES THEN PULL OUT THE BLIND ITS TWO SHORT TO CLIP IN THE SIDES. I HAVE PURCHASED TWO AND WAS TOLD THAT THERE FOR MY model BUT I HAVE HAD TO SEND BOTH BACK AS THEY DONT FIT. ANYBODY SELLING ONE OR COULD YOU TELL ME WHAT BONE I NEED .

Hi all. Just thought I'd comment on access to the oil filter Mk2 2.0 petrol) in case anyone didn't already know! All the guides seem to state that you need to raise the car up to access the filter. We'll, having just changed mine I can tell you that's not necessary. If you point the steering to the right, you can easily reach the filter through the wheel arch. Simple. Next on the list is valve clearances...

I need new tyres, what are the best for long life, at the moment i have Bridgestone Duelers fitted. Also the nearside rear tyre is wearing on the outside edge, i would appreciate some thoughts on this.