CR-V 2007 to 2011

Hi Folks I would like to isolate the power to my driver door mirror to determine if the led indicator repeator is blowing my fuse no 10, as described in an earlier post, is there there a connector somewhere between the fuse board and door pillar. Alamo

Hi folks, my car keeps chucking up a P1401 code even after replacing the EGR valve, any advice on what it could be would be appreciated, thanks Russell .

The garage has just checked a leak in my power steering and informed me that he cant get the parts due to the age of my vehicle. He suggested I use Google or ask on a forum, so here I am! Can anyone suggest a supplier? It’s a Honda CRV 2007 diesel, I’ve tried Google but I’m not sure what I’m looking for. The mechanic said it was the steel power steering pipes that feed the steering rack which have corroded. Is there anyone on here who could offer some advice? I’m wondering if it’s time to go car shopping but I love my Honda! Thanks in advance

Was just wondering if anyone out there with the CRV clock problem got a surprise today as my clock has reset itself today

Can anyone help me with information regarding moving the driver seat further back . I need to remount the rail back to allow me more legroom . I placed an order with extend my seat.com in the states for a set of brackets, but after waiting for 6 weeks they have refunded my money because of stock shortage. Ideas appreciated , thanks .

Hi All, I have a 2007 CRV, and a 2010 Wiring Harness for tow connection - part number 08L91-sww-6 -12N Problem i have is the 12N (7Pin side) has been chopped off. Looking at the wiring, i think i have figured out all the wires, except one! Pics attached, but essentially i dont know where the red+Black wire goes. From the harness, it looks like it goes to the right side cluster (looking at the car from the back). The harness itself looks like it replaces the existing one in the car with the blue connectors going in between the exiting wiring. I have duplicate blue and grey which i believe is for the fog light, wi…

Hi. Can't find a single pic or video for this. Anyone know where the knock sensor is on a 2013 CRV 2.0 EX please? Is it at the rear beneath the inlet manifold, does IM need removing 😞

Just joined this owners club so hi everybody. The rear screen wash jet is just dribbling water with no force and no fan shape. When one of the front jets was the same I had to lift the jet out and blow it clear with an airline as poking it with a pin did not work. Does the rear jet come out and if so how do I do it and should I be inside or outside the car? Thanks to anybody replying and thanks for reading my query

Hi have a 2008 crv with a basic radio which want to upgrade what loom kit do I need to use for an android unbranded radio

I am a senior who really likes his new CRV but I just discovered fishing in a bass boat. The problem is bass boats are heavy and expensive. Is it nuts to tow a boat that is a couple hundred pounds over the 1500lb tow rating. All my fishing is 15 to 20 minutes away from my home and fairly flat. Any thoughts and yet I am going to add a transmission cooler just to be safe. I would appreciate anyone who has experience with this and their thoughts!! Thank you!

I have a 2009 CRV that occasionally makes a rattling and clicking noise from the alternator area and the VSA warning light comes on. I think this subject was touched on a few years ago. Would anyone have any further thoughts on this? Any help much appreciated.

Dear Forum, I have a question if I may please ? we have unfortunately lost one of our keyless fobs for the above vehicle. I've contacted 2 dealers to get prices for replacement keyless fobs, both have quoted eye watering prices, we are talking nearly £500 from one & £650 from the 2nd ! I expected a replacement to be expensive but wasn't prepared for those kind of prices. I'm just exploring different options, we may be able to claim from home insurance for a replacement for example. Are there any independent replacement key specialists that anyone would recommend or is this dealer replacement only ? Thank you in advance for your considered opi…

I find it quite dfficult to check the level in the coolant reservoir of my 2005 CRV. The reservoir is buff coloured and I'm never sure i'm seeing the level the best I have found is hold a short stick on the outside - bottom to the top mark, then hold the stick in the reservoir and see how far up the coolant comes - must be a better way??? please anyone

Hello, I am new to these forums and looking for some help. My son's CRV has showing a dashboard warning light (not sure what). He had a small independent mechanic take a look and the feedback was The car has a fault with intake air temperature sensor requires modified sensor and a ecu software update, but it needs to go to a Honda garage I fear that a Honda garage will be an expensive bill for him (young family with three kids). Can this be done by an independent specialist? All answers very gratefully received. PS He lives near Perth in Scotland in case someone can recommend and independent

Hi all. I have a 2016 Honda CRV 1.6 dtec 9 speed automatic and I'm getting conflicting reports on how many litres of oil are required when changing the gearbox/transmission oil? Can anyone advise for certain please.

Hi, I bought a used 2019 CR-V Hybrid about 3 months ago. The 12 V battery has gone dead and needs replacing. All the online auotomatic battery selector sites (RAC, Halfords, Euro car parts etc) select 175mm wide stop-start battery for it that doesn't fit (I know I bought one!). the existing battery is 125mm wide. I cannot find a stop-start battery in this width anywhere. So what I am wondering is whether I actually need a stop start battery - is this battery getting used each time the engine starts, or does it sue the hybrid battery to start it? Anyone successfully repalced a battery in one of these? Thanks …

Please can anyone help. On my car are 225/60 r18 100h m+s tyres and on the car it says the pressure should be 30 front and back but on the tyre it says 40psi. Please can anyone let me know what I should set the tyres at. I do some caravan towing so will that make a difference. Thank you.

I have a 2007 CR-v 2.2 which has a radio/cd system which has only3 connectors, does any know of a way of upgrading to a multi connector sat/nav system may by way of a loom upgrade. Malcolm.

Hi I'm wondering if any 1 can help.steering is very heavy all the time also steering wheel trays to kick back at 2 o'clock and 10 o'clock.any feedback would be greatly appreciated

honda crv 2008 airbab light on

Anybody know where I can find the paint number for a 2020 Honda cr_v please. I do not appear to be able to find it anywhere.

The problem tends to occur after driving for 25-30 minutes, so most often on restart (clutch pedal depressed) after auto-stop. On depressing the clutch pedal, there's about 1-2 seconds of screeching/grating as the starter motor kicks in. This doesn't sound great, but is intermittent, in that you can predict roughly when it might happen, but can't reliably repeat the symptom. We took it back to the garage who sold us the 3-year-old vehicle back in November, but they couldn't repeat it either. It only ever happens a couple of times and then never again on the same trip. It's obviously in some way connected to engaging the starter mot…

What stereo harness do I need for my CRV EX IDTEC 2012 MK3, My new stereo has a 16 pin at the back of it and were will I get it from please

Hi all I have a 2017 CRV and the tyre pressure monitor has come on and I have been told by my local dealer that it’s because I recently changed a rear tyre due to a non repairable puncture and the replacement tyre doesn’t match the other tyre and that they should only be changed in matching pairs although they are both the same make and the other one was a new pair three months ago, is this correct.

Hi, I wonder if anyone can offer some advice please. I have a 2016 Honda CRV on a 1.6 diesel. I am changing the air filter and I have undone all three clips. However for the life of me, I am unable to remove the housing to access the filter. I can see that here appears to be two slots to the right that the housing fits in, but still having a nightmare. Any tips please.