CR-V 2001 to 2006

2006 2.0 petrol auto CRV MK2. Had catalytic converter stolen few weeks ago - have now replaced full exhaust system including both sensors. Car starts and runs fine but 6 seconds after starting get er message for open circuit on the O2 sensor connected to the catalytic converter Have tested output and tried replacing sensor but same problem. Note that original sensor had a blue connector but all replacements seem to have a grey connector and same part number - not sure if this means anything. Auto electrician has suggested that output is only 6 ohms and should be above 10? Thanks for looking - appreciate any thoughts.

Hello all, new to this forum after failing to find the Honda Karma UK forum. Does anybody know what has happened to it ?

Had a flashing Green D (Drive) light on the CRV this afternoon, it lasted for about 2 minutes. A minute from home we noticed the flashing D light. Parked in the drive and turned off the ignition. Checked the manual, It said 'Possible transmission problem'. May sometimes be accompanied with a warning sign as well if there is a problem. There was no warning sign that I was aware of, but I went back out to check. When I started the engine everything was as normal. No flashing D light and no warning light. I have not seen the flashing light since.. has anyone else had this?

When I bought my CR-V, the rear wash did not deliver water to the rear screen. The wiper works fine. I set about it one day and pulled the screenwash through by suction. I reconnected the washer pipe and it produced a lovely jet down the rear screen. I tried it a few times in the following days and it was great. However, with the dry spell we're having at the moment, I haven't had to use the rear wash. I tried it again a few days ago as the rear screen was a bit dusty, and nothing, just an occasional drip. Can anyone give me an idea why the screenwash keeps disappearing and will not pump up again please? It's very annoying rather than life threatening. Thanks in adva…

Hi I have a diesel crv mk11 2006. And I can't seem to find a drivers side (uk) wing mirror glass to fit it. I thought I'd found one on amazon but the back is totally different. HELP!!!

Hi All i am hoping someone can help me. i have an 06 MK11 CRV 2.2 CDTI it has recently developed a knocking noise on the front which i am unable to find the source of nothing cam up on the MOT and i asked them to look hard this isn't the most worrying thing though. When accelerating especially in second i get a strange vibration/wobble coming up through the car. It seems to be when the car is in the power band as the turbo comes on for example. Does the CRV suffer from drive shaft issues or prop bushes? The vibration was defiantly more noticeable when towing. i had the clutch and fly wheel replaced just over a year ago at Honda so i am hoping that it wouldn't…

Near side issue with side light/ front and rear fog lights

My daughter and I each have a Honda CR-V mine is a 2006 reg 2007 and my daughters is 2010 model,we have noticed on both cars that the drivers side front tyre keeps on losing air, and we obviously keep pumping to get back the required tyre pressure. After a few days the tyre pressure goes down. This happens continuously over a number of days. Both cars have been back to tyre companies who clean the wheel and that’s it, unfortunately the tyre companies have been unable to correct. The situation in either of our cars, help can anyone suggest a remedy, the tyre conditions are nearly new on both cars, and it is only the front drivers side tyre that is affected

Hi my car is a 2006 2.2 diesel CRV. I keep getting the following fault on my diagnostic unit. I have read this relates to the heater plugs but they are all working well and I can get the fault for several minutes after getting going. After that it stays off until the next time you use it. It puts the car into limp mode so I am presently resetting it every time I use the car which is a pain. Any help would be greatly appreciated thanks.

Hi, I want to use a fault reader but can't find where to plug it in.crv 2005 2.2 executive. Thanks Carlos

Hi all. Just thought I'd comment on access to the oil filter Mk2 2.0 petrol) in case anyone didn't already know! All the guides seem to state that you need to raise the car up to access the filter. We'll, having just changed mine I can tell you that's not necessary. If you point the steering to the right, you can easily reach the filter through the wheel arch. Simple. Next on the list is valve clearances...

I hope someone can please help me as I'm running out of ideas. My Diesel has a whirring noise in time with the engine revs. It still does it with the drivebelt removed. It's not the turbo . With a stethoscope the noise is definitely coming from the region of the egr cooling valve, but the valve has no rotating parts. It also has pressure when the oil cap is removed but nothing from the dipstick hole. It runs perfectly and doesn't smoke. . The injector washers have been changed. Any suggestions gratefully accepted thanks

Can anyone tell me the size of the nuts/covers to hold the upper engine rain/dust cover in please on a 2005 CRV please. Also where I might get them looked on ebay couldn't find anything. Thank you

Hiya My rear suspension is appearing to be (it is) sagging on the off side. The whole of the rear suspension seems to be lower than maybe it should be but is noticeably lower on the O/S. I've heard an intermittent clonk which appears to be coming from there over big speed bumps or dismounting a kerb. Rear Shocks? Springs? Ideas on how I could check this? **EDIT - I've just been under the car again and the spring has snapped! Not sure how I missed that!!??!! Cheers Jon

I need new tyres, what are the best for long life, at the moment i have Bridgestone Duelers fitted. Also the nearside rear tyre is wearing on the outside edge, i would appreciate some thoughts on this.

This forum seems to have very few posts and most of what's here, seems to be old. Is this because Hondas are so reliable, folk don't ever have to work on them? Thank you! J.

Anyone had their cat stolen recently? I have so I tried this. Unbolt the bottom bolt on the nudge bars and lower them and drill new holes in the support brackets then bolt in new position. Thief can no longer get under vehicle. Then purchase a 120db PIR detector (cheap) and attach it anywhere underneath with magnetic strip so if thief jacks up car and goes underneath it will go off and scare them off. Cheaper than a new cat

Anyone ever fixed/replaced the bumper mounted headlight washers on a Mk2 CR-V, ive got one broken

hi,I have a crv 2006 the heater blows cold air only ive flushed the rad and the heater matrix and its just about warm as any one had this problem.thanks tony

i need to carry a large package, i fold the rear seats down but i cannot remove the blind that covers the storage area any ideas???? jim

Hallo everyone! I am new here and don't know who is out there! Just bought a nice CRV Sport and everything is fine except the radio seems to be the basic model with no sat nav and if it has a changer other than the interface I have not seen it. For a car registered in 2007 this kit is a bit basic and I wondered if anyone knows of a product from here or China that is a good replacement for this model. Bluetooth and sat nav would be nice but I have a Tom Tom so the latter is less important. Thanks in advance. Julian

Hello I have just purchased a new Kenwood DAB radio which comes with a windscreen mounted aerial. I have a 2005 CR-V with the side curtain airbags installed in the front a-pillar. I need to remove the pillar cover to install the aerial. I have looked online and cant seem to find much info on how, and if its safe, to remove it. In the Haynes manual it says any panels with a clip with airbag printed on it should only be removed by an Honda mechanic! I have attached a couple of pictures of the said panel. Any help would be much appreciated. Regards

Does anyone know how i can get the side hinged rear door open. The top glass part will open but the door wont. There is no handle on the inside.

Hi, any advice on how to solve this would be much appreciated, as I imagine it will cost me a few quid to sort it. Brief synopsis: The car is an 11 reg plate and as one who drives around loads with the job I was getting sick of road layouts being different in reality to what the sat nav still thought. I purchased a newer disc (eBay, sorry!) and it worked fine for quite some time. It then began to produce an error and told me to contact the manufacturer. As that wasn't expensive I don't mind binning it (I thought!) and took it out and replaced it with the original, which had caused no issues other than being a decade out of date. However…

smell of burning oil has crv 2.2i-ctdi got a pvc valve