CR-V 2007 to 2011
275 topics in this forum
-
Hi All. After breaking down in my 2007 crv 2.2 diesel I had a new intercooler fitted and my turbo was sent off to be rebuilt. All seemed fine until last Sunday. I was driving on the flat at approx 60mph having done approx 30 miles. No warning lights, no noises, no smoke but from nowhere I had no throttle response and the revs started dropping until it cut out. I switched everything off, started engine again and off I went until the same happened again about a mile further. RAC detected nothing including on their diagnostic device. Took it back to the garage who stated everything was in full working order and no faults or error codes were found when they ran a diagnostic c…
-
- 0 replies
- 1.9k views
-
-
I'm new to the forum and couldn't find a thread dealing with this. We have just bought a 2012 CRV 2.0 EX (3rd gen). and wondered if the steering wheel controls (media, cruise etc) are supposed to be illuminated at night. I have seen some photos on another forum suggesting they should be, but ours aren't. if they should be, I can start trying to fix. Otherwise I guess we'll learn the buttons eventually! Can anyone confirm yes or no to this?
-
- 11 replies
- 2.7k views
-
-
Hi. Can't find a single pic or video for this. Anyone know where the knock sensor is on a 2013 CRV 2.0 EX please? Is it at the rear beneath the inlet manifold, does IM need removing 😞
-
- 2 replies
- 1.4k views
-
-
C.R Technology manufactured unit (UK) 30% power and torque improvement on the 150 bhp engine Virtually new Contact me for more info if you are interested
-
- 0 replies
- 1.5k views
-
-
Hi I'm new to this forum and just need some advice on what I know is a common CRV problem, the rear diiferential. My car is a 2008 petrol automatic, 92,000 miles. I've only owned the car for 7 months, it has a nearly full Honda service history. I had the car serviced at a local Honda dealer four months ago and asked them about the lumpy idling and slight graunch after I've reversed off my drive on full lock and then heard the noise just as I pull away. They said the car behaved like any other CRV and there was no issue. After looking on the internet I realised what the problem was and got a trusted local garage to change (and hopefully flush) the r…
-
- 1 reply
- 2.1k views
-
-
Hi Can someone advice me on how to best (and cheaply) update the sat nav on my CR-V? I have a 2012 CR-V EX I-VTEC and the sat nav is pretty rubbish, not taking me the most efficient and shortest routes. I dont want to take it to a Honda dealer as I they'll charge an arm and a leg. I heard that I can update with a DVD found behind the display panel but I can't see how it's done on my model. I've attached a photo of the sat nav. Thanks in advance!
-
- 3 replies
- 4.2k views
-
-
Hi all,I have a 2013 2.2dtec auto with 80,000 on the clock.It is the first time I have had it serviced in my ownership and a bit puzzled at what sensibly needs doing.Does it need brake fluid,transmission fluids,fuel filter etc?.I have had a few quotes,I am told it needs new discs and pads all round as well as a service,approx £730 seems to be the going rate??...any advice please..cheers,Phil.
-
-
- 2 replies
- 2.9k views
-
-
Hello there, my 2007 crv had a dramatic decrease in power whilst driving home. since recovering it to my mechanic the engine will start and the cut out after 1-2 seconds. we have replaced filter, and replaced the fuel pressure regulator and still no good. anyone here have any idea what the problem may be? thanks I’m advanced Ryan.
-
- 2 replies
- 1.9k views
-
-
Just bought myself a 2007 crv. Only fault is the stereo, only playing through the tweeters and nothing else. Think we've narrowed it down enough to establish that it's the stereo itself that's buggered. Looking for advise on replacing it with one with sat nav but a little dubious about an eBay aftermarket one, anybody got any recommendations?
-
- 1 reply
- 3k views
-
-
Hello everyone, this is my first time posting on here, hoping someone can help. I have a 2008 CRV 2.2 diesel, starts first time when cold and runs perfectly even down the motorway. Problem is, once you turn it off it will not start again for 2 or so hours when its cooled down, it just turns over and displays engine light and VSA & TSA. Once cold back to normal again!! Main dealer has said the ECU is not holding its memory and needs a new ECU at £1700. Had a second garage take a look and they have said ECU memory is all there it's just not communicating when warm. Suggested a second hand ECU and swapping the data over. my questi…
-
- 6 replies
- 3.2k views
-
-
As owners of a 2013 CRV, we are looking to purchase 2 electric bikes and need to find a way to transport them. They would each weight 24 kgs. As we tow a caravan and want to take the bikes with us we cannot use a tow ball fitting carrier. Would prefer a rear vehicle option but are having difficulty finding a suitable one. Have seen roof mounted options but as these bikes are quite heavy a) they seem to be too heavy for the roof bars and b) as we are not getting any younger we are not sure we would be able to lift them anyway. Wondering if anyone else has come across this and has found an answer.
-
-
- 2 replies
- 5.8k views
-
-
I am looking for advice on which dash cam the group recommends please
-
- 1 reply
- 1.3k views
-
-
2007 (gen 3) Honda CR-V EX 2.2 i-ctd-i 6 speed manual. The dash clock in the navigation/entertainment centre will not retain time after it is set and then the ignition is turned off, BUT it will keep the time if the ignition is not turned totally off even with the engine not running. If the ignition is kept on Aux, the run position or the engine is running it is fine. Is there a fuse or relay that controls this? I have disconnected the battery, waited 30 minutes then reconnected it, reset the radio code , the ECU then reinitialised the security system but it had no effect. 8 attempts so far and always the same result.....HELP please.
-
-
- 3 replies
- 2k views
-
-
Hi folks. Bought an 07 CR V 2.2 i cdti. It's got Full Service and 147k on it. Hellish obvious Turbo Siren noise at around 2.5rmp and more. I'm hoping to check for Oil Starvation to the Turbo? It runs amazingly well. Boost great and goes like a small rocket. Or has anyone got any other ideas? I had the exact same noise on an Alfa Romeo 159 a few years ago and the turbo bearings whent resulting in a cloud of black smoke. Any advice on what I can check on the drive? Thanks in advance.
-
-
- 3 replies
- 4.7k views
-
-
-
Hi, hoping for a light bulb moment from avid CR-V fans. My DPF alarm illuminated on the dash about 3 months ago and went into limp mode. The garage conducted a force regen and sent me on my way. All was good for about 2 months until it happened again. This time my local garage couldn't clear the fault so I took it to a terra clean "specialist" who charged me a small fortune, cleared the fault, force regen again and said that all my stats were good and maybe my previous garage didn't regen it correctly. Fast forward 25 miles and it's back on. Any thoughts please? Because I can't keep taking it in for them to charge me the world and it go wrong in le…
-
-
- 3 replies
- 3.1k views
-
-
I am hoping someone can help me please, I have a 2012 Honda CRV and I have a DPF light with exclamation mark on, RAC said the car has already done a regeneration and doesn’t need a forced regeneration but the computer hasn’t realised and turned the warning light off. Has any one had any experience of this and any solutions. I took it for a DPF diagnostic and they said the light went off but came back on instantly. Any help would be greatly appreciated. Thanks
-
-
- 6 replies
- 4.3k views
-
-
Good Morning Folks. I'm getting a clicking noise occasionally about 3 secs after I pull away on my auto CRV. My garage can't replicate the issue but say there is some play in one of the front drive shafts. They are saying that none of the motor factors they use carry them and it would have to be direct from Honda £725.00. They did find somewhere that recon them but they are dubious that they can get the parts to recon it if they send it to them. As the click is only minor at the moment and they cannot confirm that it is that I'm going to wait till it gets worse to confirm it is that and not a wheel bearing maybe. My baby has just hit the 129000 mark so gu…
-
-
- 4 replies
- 2.3k views
-
-
does anyone know of a manufacturer who makes o/s front wishbone with a bracket to attach rod for self leveling switch(zenon lights).plenty without the bracket at reasonable cost.Only managed to find genuine HONDA wishbone which has the bracket at a cost of £730.Alternatively is it possible to get old one re -bushed or perhaps improvise a bracket,though as i understand its not a good idea or legal to weld small bracket.Any help or advice would be greatly appreciated.Thanks
-
- 1 reply
- 1.1k views
-
-
We purchased a 2 wheel drive 2014 CRV in 2017 with 33,000 miles from a Honda dealer. On way home we noticed it shuddered at 60 mph. Took it back and eventually they changed both driveshafts. Fast forward another 36,000 miles and it’s started again. Honda have said it needs new Driveshafts again at a cost of £2,000. Cars now 8 years old and completed 70,000 miles, but to need 2 sets of driveshafts seems crazy. Has anyone else heard of this issue?
-
- 0 replies
- 1.1k views
-
-
Have just bought a 67 plate CRV SE + NAVI 1.5 EcoDream engine. System management light showed twice - issue with the engine. Appears there is known problem with this engine regenerating and/or fuel injection. Wish had looked online before ! Is this isolated or is this a common issue? No Honda fix it seems. Are people living with this or is there something that stops it ? Thank you .
-
- 0 replies
- 1.8k views
-
-
Power steering fails spasmodically. Does anyone have experience of this?
-
-
- 5 replies
- 3.2k views
-
-
Hi All, Thanks for the forum add I'm hoping someone can help me with an issue I'm having with a 2015 C-RV. The car is a CRV SE Navi, 4WD, 1.6 diesel and hase covered 65k miles. My question is, having had the dpf light come on and the car go into limp mode, the car has been in the garage and the dpf cleaned and refitted and is now back to full working order, sadly on returning from the garage the engine light came on again and I headed back thinking it would be dpf related. Having been plugged in at the garage the fault was F4 which relates to the Air Flow snesor and is something we had replaced only a year ago, this has confused the garage as the…
-
- 1 reply
- 1.8k views
-
-
New member 1st time post! My 2018 1.6 diesel auto CRV (bought from new) had been sitting on the drive not doing anything for 2.5 weeks and then I ventured out to to the shops but knew it would need a little run out but, 5 mins in to the motorway journey to the supermarket, it went into limp mode for the 1st time and then I also got the warning sign that the start/stop won't work as the battery is too low! I limped home and left it a day. then took it out to try again and basically run all the kinks out. I drove for 30 mins and on the motorway at high-ish revs and the low battery start/stop warning light went off but the engine management light stayed on. Its a …
-
- 1 reply
- 1.9k views
-
-
Mk3.2 crv 2.2 148bhp diesel 2011. just had the clutch and fly wheel replaced. Since the work has been done the engine engine sound inside the cab is a lot more noticeable. Its not a fault noise just normal engine noise. It's almost as if some sound proofing is missing or a grommet is not put back properly. Ive searched but cant see anythingout of place. Any ideas
-
- 0 replies
- 846 views
-