Honda FR-V Club
Discuss the Honda FR-V
166 topics in this forum
-
Hi, my vehicle is suffering rear inner edge tyre wear. I am aware there is some adjustment that can be made on the lower arms, my question is - is there any adjustment that can be made to rear wheel alignment. I believe that the 'adjustment ' nut impacts on the rear camber and is adjustable for each wheel. Anyone can provide some more information on the subject or point me in the right direction ? My vehicle has clocked up 145k miles and has always been a bit heavy on rear tyres, even after 4 wheel alignment at a reputable garage chain, in fact on that occasion an adjustment was made but insufficient adjustment to be within tolerance. The cars history is known …
-
- 5 replies
- 830 views
- 1 follower
-
-
Hello I'm experiencing a problem in locating a replacement radiator for my frv 06 model, on an engine code D17A2. There doesn't seem to be any available. As you can imagine money is tight. Any solutions to my problems.
-
- 5 replies
- 1.9k views
-
-
Hi everyone i have a FRV 2005 plates the engine check light is on and is giving a fault code temperature sensor 2 fault the connection is corroded can any one suggest where i can purchase one or i have to buy a complete harness
-
-
- 5 replies
- 4.9k views
- 1 follower
-
-
Hello to all, My Civic mk9 2.2 idtec condenser is leaking and my local Honda garage was going to charge me £700 to replace which i think is asking too much. Just thinking how easy to replace it myself, just needs re gassing afterwards, i have basic mechanical skills but never had to do this sort of work. any reply's will be very grateful.
-
-
- 4 replies
- 2.7k views
- 1 follower
-
-
Had a man check air con as not working - air con circuit dead to air con clutch. I then recalled that I had a error code reader although no fault on the dash appeared. Code P645 is the error code. So where do I go from here. I do recall several months ago the crunching of something and when turning off air con it went away. So I left it off. Recently turned on air con and no noise but no air con either! What needs to be replaced please and anyone know the part number. I think it is the air con clutch assembly but can I find one...no I cant ! Thanks Bobbybiscuit
-
- 4 replies
- 2.8k views
-
-
Hello does anybody know where the PGM FI relay is ? Iv got a 2005 1.7 FR V that iv just replaced the head gasket and all the belts on. It worked fine for 20 miles or so, making various stops for shopping and then on the motorway it just cut out and wont start at all. Theres spark from the plugs and fuel is pumping to the injector rail but they're not firing. apparently the PGM FI relay is a common fault on Hondas and when they fail either the fuel pump stops working or the injectors. The pump is pumping. So i just need to find it and test it or swap it with the one in my other FRV which the clutch has gone on. Iv looked on both fuse boards plus looked behind the glove box…
-
- 4 replies
- 4.5k views
-
-
As Per the title really, car was working fine until Saturday morning..occasionally over the last year or so on a handful of occasions had the passenger door failed to open. But a double press on the fob and we were all ok again. Friday it was fine, on Saturday morning however things did not go to plan. Went to open the car, and nothing on the passenger door unlocked and relocked the car with the fob multiple times, but still no good. I've managed to remove the interior door card, and get to the actuator but of course the whole thing is one effing sealed unit isn't it, and without being able to open the door I can't remove the bolts inside the door to remo…
-
-
- 4 replies
- 2k views
- 1 follower
-
-
Hello all, I am out of ideas and hoping someone can share their ideas and suggestions. I have an 2008 FR-V 2.2 diesel with under 120k miles but for last couple of years it has been hardly used. I replaced all four brake discs and pads as first thing due all brakes being very rusty, only noticing driver side rear calliper was a bit stiff but managed to compress all cylinders without excessive force. Went on to the road and the stiff calliper started to smell badly and brake disc turned darkish (obvious overheat). I naturally thought calliper seized, so took it apart but only found seal slightly trapped (fitted improperly). May I also note all four c…
-
- 4 replies
- 4.1k views
- 1 follower
-
-
Hello Looking for ideas here. I had a catalytic converter and lamda sensors stolen. I bought replacements online (onlineautomotive.co.uk) and a few months later it started tripping the engine management light - P0420: Catalyst System Efficiency Below Threshold (Bank 1). I'm now wondering about trying to get the catalytic converter replaced under warranty and wondering what is the best way to go about it? They understandably want to pick it up, but I need to use the car in the mean time if there is a delay until they send out a replacement or refund. Also wondering if there's a possibility they'll take it and then try to…
-
-
- 4 replies
- 1.5k views
- 1 follower
-
-
The Honda FR-V (Honda Edix in Japan) is a six-seater compact MPV introduced by Honda in 2004 and marketed until 2009. Alongside the Fiat Multipla, it is currently one of only two compact minivans with a 3+3 seating configuration available on the European market. Engines The FR-V is available with three gasoline and one Honda diesel-powered engine. 1.7 i-VTEC - 125 hp (93 kW; 127 PS) at 6300 rpm and 154 N·m (114 lb·ft) 4800 rpm 1.8 i-VTEC - 138 hp (103 kW; 140 PS) 2.0 i-VTEC - 150 hp (112 kW; 152 PS) at 6500 rpm and 192 N·m (142 lb·ft) at 4000 rpm 2.2 i-CTDi - 140 hp (104 kW; 142 PS) at 4000 rpm and 340 N·m (251 lb·ft) at 2000 rpm The 1.7 i-VTEC and 2.0 i-VTEC were …
-
- 4 replies
- 16.6k views
-
-
The kids have finally broken one on the front-middle seat back cup-holders on my 2007 FR-V. Is anyone au fait with how to remove the whole unit so I can investigate? Thanks in advance, David (_8(|)
-
-
- 3 replies
- 1.7k views
-
-
Hi All, I have a Honda frv auto petrol 1.8 2008 model. I have been having this issue with my FRV for a while, when in park my engine will intermittently vibrate it sometimes can vibrate very aggressively if I reposition the steering a little the vibration will die down for a moment and start up again until I reposition the steering or it eventually stops vibrating it self. This mainly happens when the car is in park or neutral. It doesn’t happen when driving. I have already replaced power steering fluid and the o ring as I thought this might be the issue unfortunately it did not help. My brakes and pads are all relatively new, my tyres are poor and do n…
-
- 3 replies
- 2.3k views
-
-
-
Hi there, Any advice on the above? 2006 Honda FRV 2.2 crdi with 110000 miles. We have come back from a long journey and VSA and ABS lights suddenly came on. Not doing anything particular at the time. Drove the car a few miles, stopped and restarted it and the light went away. Drove normally, no problems but then this happened again several times. I knew we had a problem anyway with the brakes as pads were low by the time we got back and have had it at the garage for a caliper replacement on the rear offside wheel as well as new pads, which needed changing. The caliper had been sticking a bit and hoped that might fix the VSA issue. However it h…
-
- 3 replies
- 1.9k views
- 1 follower
-
-
Hi. Does anyone know where I can get a bottom ball joint for my Honda 2.2ctdi FRV 2006? I was told by Honda that I couldn't buy just the ball joint and would have to buy the complete hub carrier for nearly £300. I ended up doing this for the drivers side (crying as I did so) but now the passenger side will soon need replacing and I am loathe to do so again. I have the old ball joint from the driver's side in my hand so I know it does separate from the hub carrier. Has anyone else had this problem and been able to overcome it? 🤞 It's not the sort of part that I want to get from a breakers because it would undoubtedly have wear issues too. Hoping someone will be able to hel…
-
- 3 replies
- 4.3k views
-
-
Hi all, our front passenger door won’t open from inside or outside on frv. Any ideas what the problem would be and how I can get it open to pull the door card off?
-
-
- 3 replies
- 1.4k views
- 1 follower
-
-
So I have this issue that unlock function doesn't always work. Or more like works once in 10-20 attempts. Its the same if you use fob or key in the handle, it turns easily and actuates the doors but then immediately locks again. Once unlocked it locks fine. Is it drivers door lock mechanism that's failing?
-
- 3 replies
- 3.6k views
- 2 followers
-
-
Hi Everyone. Driving back home yesterday after a 40mile run my engine stopped about 500 metres from my house. It wouldn't start again (plenty of fuel). After 5 mins it started again then just died straight away and did this a few times. After it cooled the engine started and runs fine but I have an orange engine light on. Any ideas? Fuel filter maybe? I'm reluctant to take it for a long run. Thanks in advance...It's the 2.2 diesel
-
-
- 3 replies
- 1.4k views
-
-
Hi Folks, great forum on here, and I'm hoping you guys can help me out, my question is, can I fit (the Honda factory fit) roof rails to an FRV that's doesn't have them? i.e. I'm looking at buying an FRV currently choosing between two models; a 2006 (low milage) or a 2009 (high milage). Im leaning towards the low milage 2006 model but I will need roof rails and the 2006 doesn't have them, so are roof rails somthing I can fit after the fact? Thanks in advance!
-
-
- 3 replies
- 2.4k views
-
-
Hi All FRV 1.8 2008 Petrol. My parking sensor just gives a contant tone/continous long beep when the reverse gear is engaged. All 4 sensors click when touched. Ive cleaned the seneors even though they werent dirty inc using wd40. Ive disconnected the battery for a bout 5-6 mins but still no joy. Any one have any suggestions what could be the cause? Or what i can do do fix it? Im not going to be able to take the rear bumper off or anything. Not sure where the control module is or how to access it? Thanks for any advice
-
- 3 replies
- 2.1k views
- 2 followers
-
-
Hi I need to replace all 4 springs at some point as they are corroded. I don’t want the car lowered so looking for similar springs. Can’t find a part number anywhere and no idea what oem springs are suitable. Does anyone know?
-
- 3 replies
- 1.3k views
- 1 follower
-
-
Hello I have a 2006 Honda FR-V, 2.0L petrol. Wondering if it's possible to get an aftermarket tilt sensor added to the standard fit alarm system, where could I get it from and how much it would cost? Thanks for any advice/suggestions
-
- 3 replies
- 2k views
- 1 follower
-
-
Does anyone know how to remove the mirror glass from wing mirror. Tried prying it from the bottom but didnt work unless it needs to be done with more force but didnt want to break it. Is there any clips that need releasing
-
- 3 replies
- 2.2k views
-
-
I am in need to replace FR-V 2009 1.8l petrol automatic right hand (driver side) drive shaft and I can't find the replacement part as it shows everywhere out of stock. Part number is 44305-SJD-E20 and I wonder if there is any alternative option for that part, maybe some other honda models share the same part but under different part numbers? I found Honda OEM part but I can't afford to spend over £500 just for part alone and also wait till mid october, so any input from you guys will be appreciated. Thank you in advance! JZ
-
- 3 replies
- 2.8k views
- 1 follower
-
-
Hi does anyone know how to remove the master window control unit from the dashboard and also if a single switch can be replaced or the whole unit needs replacing. The driver window switch has become loose. thanks
-
-
- 3 replies
- 4.3k views
-